Cobalt Digital Inc Cobalt NASRaQ Manuel d'utilisateur télécharger pdf (Page 150)

Appendix A

136

First, conﬁgure the RaQ 3 that will serve as the master. To conﬁgure the

RaQ 3 for the UPS:

1. On the LCD console, hold down the button for approximately

2 seconds.

The LCD screen displays:

SELECT:

SETUP NETWORK

2. Press the button until Conﬁgure UPS appears in the LCD

screen:

SELECT:

CONFIGURE UPS

3. Press the button.

4. Use the arrow buttons to toggle the cursor between [ ] On and

[ ] Off. Select [ ] On.

5. Press the button.

6. Use the arrow buttons to toggle the cursor between [M]aster and

[S]lave.

7. Press the button. If you choose [M]aster, the RaQ 3

conﬁgures itself automatically for the UPS.

8. If you choose [S]lave, the LCD screen prompts you for the

IP address of the RaQ 3 conﬁgured as the master.

Enter the IP address using the arrow buttons. The left and right

arrow buttons move the cursor position to the left or right. The up

and down arrow buttons increase or decrease the digit at the cursor

position.

9. Press the button.

The LCD screen returns to the host name and IP address. The LCD

screen does NOT prompt you to save the changes.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 207 208

Pas de commentaire

Cobalt Digital Inc Cobalt NASRaQ Manuel d'utilisateur Page 150