Cobalt Digital Inc 2000 Manuel du propriétaire télécharger pdf (Page 12)

9232 Owner’s Manual (V 1.1 12

5. Align the top hole of the rear module with the screw hole on the top edge of the

frame back plane.

6. Using a Phillips driver and the supplied screw, fasten the rear module to the back

plane. Do not over tighten.

7. Ensure proper frame cooling and ventilation by having all rear frame slots covered

with Rear Module or blank metal plates. If you need blanks, refer to the chapter,

“Ordering Information” in your frame Owner’s Manual, and contact your Cobalt

Digital sales representative.

This completes the procedure for installing the Rear Module in a 8300 series frame.

Board Installation

Use the following procedure to install the 9232 in a frame:

1. Refer to the Owner’s Manual of your frame to ensure that the frame is properly

installed.

2. After selecting the desired frame installation slot, hold the 9232 card by the edges

and carefully align the card edges with the slots in the frame.

3. Fully insert the card into the frame until the rear connection plugs are properly seated

on the midplane and rear modules.

This completes the procedure for installing the 9232 in a frame.

BNC Labels

Affix the supplied BNC label, as per the included instructions, to the BNC area on the rear of the rack

frame.

Cable Connections

This section provides instructions for connecting cables to the installed Rear Modules on your frame

backplane.

Connections for the Rear Modules Frames

The input of the 9232 can be terminated on the card depending on the rear module used. It is not

necessary to terminate unused outputs.

The 9232 may be used with the following Rear Modules:

• RM20-9232-B Standard-Width (Full) Rear Module and RM20-9232-B/S Split Rear

Module — Each card provides eight outputs and one looping output. If the input is

looped on the rear module to another device, JP1 must be set to LOOP. If looping is

not used, either set JP1 to TERM, or terminate the input externally at BNC 2.

• RM20-9232-A/S Split Rear Module — Each card provides four outputs. If the input

is looped on the rear module to another device, JP1 must be set to LOOP. If looping

is not used, either set JP1 to TERM, or terminate the input externally at BNC 2.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Pas de commentaire

Cobalt Digital Inc 2000 Manuel du propriétaire Page 12